Owner manual

Switching Operation Screens
4-29
IM 04L42B01-01E
1
2
3
4
5
6
7
8
9
10
11
12
13
App
Index
Carry out the procedure below to switch the displayed report data.
Up arrow key: Report data being displayed + 1.
Down arrow key: Report data being displayed – 1.
Left arrow key: Report data being displayed + 10.
Right arrow key: Report data being displayed – 10.
Note
The display is not updated even if a new report is created while displaying the report data.
Perform either of the operations below to display the most recent report data.
• Hold down the left arrow key until the latest report data is displayed.
• Press DISP/ENTER and display the report data again from the display selection menu.
• Switching the Report Channels
Up to 30 report channels can be shown on one screen. If there are more than 30
report channels, you can switch the displayed report channels.
1.
Press DISP/ENTER to show the display selection menu.
2.
Press the right arrow key to display the sub menu.
3.
Press the up and down arrow keys to select CHANGE REPORT CH.
4.
Press DISP/ENTER.
The displayed report channels are switched.
• Relay Status Display
Lists the statuses of the alarm output relays and internal switches. You cannot change
the settings on this display.
Red: ON
Green: OFF
• Modbus Status Display
Lists the statuses of the Modbus client or Modbus master commands.
For the operating procedure, see the Communication Interface User’s Manual,
IM04L41B01-17E.
Communication conditions
Status
Command
Communication destination
DX channels
4.5 Displaying Various Information