Owner's manual

IM 04L42B01-02E

Connecting to an Ethernet Network

Setup Example 10: Automatically Transferring the Measured Data File to an FTP

Server

In this example, we will configure the DX so that the measured data is automatically

transferred to an FTP server on the network when the measured data is automatically

saved to the CF card. To automatically transfer the measured data files and report files,

the auto saving of the measured data must be configured in advance (see “Data storage

method” of the setup example 5).

This example assumes that the following network environment is used: DHCP enabled,

automatically obtain the DNS server information, and automatically register the DX host

name to the DNS server. Set the parameters according to your network environment.

Measurement input

Ethernet

Automatic data transfer to an FTP server

CF card

FTP server

Internal

memory

Setup Item Description Number in the Figure

Host name DAQSTATION1 1

Obtain the IP address Obtain automatically (DHCP) 2

Type of data to be transferred Acquired measured data 3

FTP server Server name abcdefg.co.jp 4

Port number 21

Password a1234

(1) Host Settings and IP Address of the DX

Press MENU (to switch to setting mode), hold down FUNC for 3 s (to switch to basic

setting mode). and select the Menu tab > Communication (Ethernet) > IP address,

Host settings.

Automatically obtain the

DNS server information.

Automatically register the

DX host name to the DNS

server.

(2) Data to Be Transferred to the FTP Server

Select the Menu tab > Communication (Ethernet) > FTP client > FTP transfer le.