User guide

14
IM 11M06D03-01E-A
When wiring electrical components, verify that electrical current and all applicable circuit breakers are
de-energized prior to wiring the AC1 and ZR402G. Ensure that all applicable “Lock Out” and “Tagging”
procedures have been adhered to. Verify the integrity of ALL electrical connections and terminations prior to
energizing the system.
A16AWG,4conductorcableisrecommendedforusebetweentheZR402GandtheAC1Unit.Thecableshouldbe
runinaseparateconduitfromthedetectorcables.Ifaconduitisnotused,thewiringshouldhaveasuitablejacket
to meet environmental and regulatory codes.
To prevent noise from interfering with surrounding electrical lines, we recommend the use of shielded cable
ground at the ZR402G.
Figure6.1
WARNING
NOTE