User Manual

<4. COMMISSIONING OF pH/ORP>

4-13

IM 12A01A02-01E 5th Edition : Oct. 31, 2013-00

4.5 Logbookconguration

In“Logbookconguration,”theuserconguresinformationtobesavedtoalogbookorinitializes

the logbooks.

Logbooks are used to keep an electronic record of events such as error messages, calibrations,

andprogrammeddatachanges.Byreferringtothislog,userscan,forinstance,easilydetermine

maintenance or replacement schedules.

In“Logbookconguration,”theusercanselect“Off,”“1-1,”or“1-2”foreachitemofinteresttobe

logged. (For sensor 2, select “Off,” “2-1,” or “2-2.”) This can be done for items displayed on the

Settings logbook 1/3 to 3/3 screens. Assigning 1-1 or 1-2 to each item allows information to be

organized and logged in a logbook.

NOTE

Some events such as power-on are saved into the logbook “1-1” or “2-1”. This logbook may be

full earlier. It is recommended that important information be saved into the logbook “1-2” or “2-2”.

For“Eraselogbook”,aspeciedlogbook“1-1”or“1-2”canbeerasedindividually.

When the “Warn if logbook full” is set to “Yes”, a warning is given when the logbook come to near

full(maximum13pages).

NOTE

When the logbook gets full, the oldest information is erased automatically.

4.6 Advanced setup

Advanced setup is used to set functions relating to matters other than measurements such as the

selection of settings, tag setting, password setting for protecting calibration and commissioning

operations, date setting, and communication setting.

(“Factorysetup”isforserviceengineersonly;thereisnoitemtobesetbytheuser.)

4.6.1 Settings

In“Settings,”selectanitemtobesetasthedefaultvaluefromamong“Noaction,”“Loadfactory

settings,” “Save user settings,” and “Load user settings.”

When the default values are loaded, the instrument will be restarted. (In the case of “Save user

settings,” it will not be restarted.)

The following parameters are not included in the defaults:

• Tag

• Thecontentsofalllogbooks

NOTE

When the “Save user setting” is only selected, save of the user-set parameters will start at once.

To avoid wrong selection, operation in this Settings must be done by

, not by touching the

menu message.