User Manual

<1. INTRODUCTION AND GENERAL DESCRIPTION>
1-8
IM 12A01A02-01E 5th Edition : Oct. 31, 2013-00
For some errors concerned with setting, a message on the remedy can jump to the relevant
setting directly.
Problem with mA and Process
parameter.
Remedy
Select a correct ‘Process
parameter’ for mA in:
Commissioning >> Output
setup
Fault:
mA configuration error
Figure 1.10 Example of jumping from remedy to setting
If neither a fault is detected nor warning is indicated, “Working properly” is displayed.
If a fault is detected or warning is indicated, up to 3 messages appear.
n Execute & Setup
Allowsyoutocalibrateandconguretheinstrument.Theseoperationscanbeprotectedwitha
password.
Execute:
Calibration
HOLD
Temporary output
Setup:
Commissioning
Change language
Start Quick Setup
Execute & Setup
Figure 1.11 Example of Execute & Setup display
1.3 Passwords
PasswordscanprotecttheFLXA21fromotherpersons’accessexceptarightoperator’s.
Execute:
Calibration/Wash
HOLD
Temporary output
Setup:
Comissioning
Change language
Start Quick Setup
Execute &Setup
Sensor setup
Measurement setup
Output setup
Error configuration
Logbook configuration
Advanced setup
Display setup
Calculated data setup
Commissioning
Settings
Tag
Passwords
Date/Time
Communication
Factory setup
Advanced setup
Execute:
Commissioning:
Entering an empty password
results in disabling the
password check.
Passwords
Figure 1.12 Example of passwords setting
ExecuteoperationandCommissioningoperationcanbeseparatelyprotectedbyeachpassword.
WhentheExecutepasswordisset,executionofCalibration(/Wash),HOLDorTemporaryoutput
needstoenterthepasswordtostarteachexecution.WhentheCommissioningpasswordisset,
CommissioningandStartQuickSetupneedstoenterthepasswordtostartthesetting-up.
Refer to the section 4.6.3, 7.5.3, 10.5.3, 13.6.3 or 16.6.3 for details of setting passwords.