User Manual

<16. COMMISSIONING OF SENCOM pH/ORP>
16-2
IM 12A01A02-01E 5th Edition : Oct. 31, 2013-00
Table 16.1 Menu Structure and Default Values in “Commissioning”
Parameter Ref. sect.
Sensor setup Sensor type 16.1
Safe sensor disconnection
Measurement setup
Measurement 16.2.1
Temperature setting
Temp. element 16.2.2
Temp. compensation Compensation 16.2.3
Reference temp.
Process Temp. Compensation
Calibration settings pH settings Zero and Slope units 16.2.4
Limits and timig
Buffers(selectset)
Zero/Slope/ITP
Auto correct (Zero, Slope)
ORP settings
rH settings
Limit and timing
Zero/Slope
Impedance settings 16.2.5
Concentration Unit 16.2.6
Sensor diag. settings Input 1 imp.: 16.2.7
FINE
Input 2 imp.:
Process time
Heat cycle:
Deneheatcycle
DeneSENCOMstatus
Output setup mA 16.3
Output
Process parameter
Setup
Linear
0 % value
100% value
Table
Burn
Dampingtime
Simulate Simulation perc.
CongureHold
Errorconguration 16.4
Logbookconguration 16.5
Advanced setup Settings 16.6.1
Tag 16.6.2
Passwords 16.6.3
Date/Time 16.6.4
Communication 16.6.5
HART
PH201G
Factory setup 16.6.6
Displaysetup Main display 16.7.1
Trend 16.7.2
Auto Return 16.7.3
Adjust contrast 16.7.4
MONITORdisplay 16.7.5
NOTE
Alltheparametersforthequicksetup(underlinedonesinTable16.1)arecrucialfor
measurement. If you change any of them, other parameters may be initialized. For the
parametersthatmayinitializeothervalues,seeAppendix1.