User Manual

<15. OPERATION OF SENCOM pH/ORP>
15-2
IM 12A01A02-01E 5th Edition : Oct. 31, 2013-00
15.1 Change language
ThescreenissettodisplayEnglishatfactoryshipment;ifyouwishtousetheFLXA21inanother
language,rstselectalanguageasdescribedinsection2.7.
15.2 Quick setup
TheQuicksetupscreenisusedtosetupthebasicitemsyouwanttosetuprst,suchasthe
date/time and sensor settings. The detailed settings are described in chapter 16, Commissioning.
YoumayleavetheQuicksetupnowandreturntoitlater;however,itisrecommendedtoperform
thequicksetuprst.
Each time the FLXA21 is started up, this screen is displayed. If it is not necessary to change the
setup,pressNoor
.
NOTE
When no operation is performed for 10 minutes or 60 minutes (depending on the setting of “Auto
Return”),thedisplayexceptTrenddisplayautomaticallychangestotheMonitordisplay(ortothe
MaindisplaywhentheMONITORdisplayisdisabled).
NOTE
The display may show “---- (bar)” when starting measurement, which means the sensor is not
readytomeasure.Butthetemperatureisdisplayednormally.Waituntilmeasurementvaluesare
displayed.
Whileabar(----)isdisplayed,asforthemAoutput,inthecaseof“Off”or“Low,”[Burn]ofthe
Outputsetup(seesection16.3)isxed3.6mA,and,inthecaseof“High,”22.0mAbecomes
xed.