User Manual

<10. COMMISSIONING OF ISC (Inductive Conductivity)>
10-11
IM 12A01A02-01E 5th Edition : Oct. 31, 2013-00
n PH201G
Select this menu if the PH201G distributor is connected to the instrument.
In the PH201G setup screen, make settings for “Hold contact,” and “Fail contact.”
l Hold contact
SelectDisabledorEnabled.
When this item is enabled, the output will be held according to the setting of “Hold type” on the
Hold setup screen.
l Fail contact
Selectastatusfromamong“Fail+Warn,”“Failonly,”and“Disabled.”
Thissettingdependsontheerrorconguration.See“10.3Errorconguration.”
“Fail” corresponds to “Fault.”
10.5.6 Factory setup
For “Factory setup,” there is no item to be set by the user.
NOTE
This menu is for service engineers only. This section is protected by a password. Attempting to
changedatainthefactoryadjustmentmenuwithouttheproperinstructionsandequipmentcould
result in corruption of the instrument setup and damage the performance of the unit.
10.6 Display setup
This screen is used to make various settings relating to screen display.
NOTE
Settable items differ depending on settings in “Measurement setup.”
10.6.1 Main display
Three measurement values can be set to display on the Main display as a primary value (1st
line), a second value (2nd line) and a third value (3rd line) respectively.
Onthe“Additionaltext”,atextofupto12alphanumericcharacterscanbeassignedtoeach
measurement value.
AdditionaltextsaredisplayedontheMaindisplay,andareusefulforidentifyingmeasurements.
Insomecases,notall12characterscanbedisplayedduetotheletters;checkthetexts
displayedontheMaindisplayaftersetting.Ifapartofthetextismissing,adjustthenumberof
characters.
10.6.2 Trend
This screen is used to make settings for the Trend Graph Screen.
Set the process parameters to be displayed for each trend. They can be set for the 1st to 3rd
trends. When all three process parameters are set “Empty”, there is no trend display (no trend
button).
ISC
10