User's Manual

P.4/4IM 01W06E01-01EN
CE Conformity:
The Authorized Representative for this product in the EEA is:
Yokogawa Europe B.V. Euroweg 2, 3825 HD Amersfoort, THE NETHERLANDS.
RoHS Directive:
EN50581
RE Directive:
Safety: EN61010-1 (Indoor/Outdoor use), EN62479
(1) Pollution Degree 2
“Pollution degree” describes the degree to which a solid, liquid, or gas which
deteriorates dielectric strength or surface resistivity is adhering. “2” applies to
normal indoor atmosphere. Normally, only non-conductive pollution occurs.
Occasionally, however, temporary conductivity caused by condensation must
be expected.
(2) Installation Category I
“Overvoltage category (Installation category)” describes a number which
denes a transient overvoltage condition. It implies the regulation for impulse
with stand voltage. “I” applies to electrical equipment which is supplied from
the circuit when appropriate transient overvoltage control means (interfaces)
are provided.
EMC:
EN 301 489-1, EN 301 489-3, EN61326-1 Class A Table 2, EN61326-2-3,
EN55011 Class A
CAUTION
This instrument is a Class A product, and it is designed for use in the industrial
environment. Please use this instrument in the industrial environment only.
Radio Spectrum:
EN 300 220-2 (Band h1.3 in table 1 of CEPT ERC Rec. 70-03), EN 300 330
ATEX Directive: See 8.1.1 (1) “Technical Data”.
Canadian Safety Standards:
CAN/CSA-C22.2 No.61010-1
CAN/CSA-C22. No.94.2
IEC 60529
Pollution degree 2
Overvoltage category I
WARNING / AVERTISSEMENT
Use only battery LS14500 C5SY (SAFT)
Utiliser uniquement des accumulateur LS14500 C5SY (SAFT)
Degrees of Protection:
• Housing material code 1: IP66/IP67
• Housing material code 2: IP66/67 and Type4X

Waste Electrical and Electronic Equipment (WEEE), Directive
(This directive is valid in the EU member states.)
This product complies with the WEEE Directive marking requirement.
The following marking indicates that you must not discard this electrical/electronic product
in domestic household waste.
Product Category
With reference to the equipment types in the WEEE directive, this product is classied as
“Small equipment”.
Do not dispose of this product in domestic household waste.
When disposing of products in the EU, contact your local Yokogawa Europe B. V. ofce.
8. Explosion Protected Instrument
8.1 ATEX Conformity
(1) Technical Data
Caution for ATEX Intrinsically safe type.
Note 1. Model XS770A Wireless Vibration Sensor with Type K2 for potentially
explosive atmospheres:
• Applicable Standards: EN 60079-0: 2012+A11: 2013
EN 60079-11: 2012
• Ex Marking:
II 3 G Ex ic IIB T4 Gc
• Ambient temperature: –20°C to 80°C (–4 to 176°F)
• Enclosure: IP66/IP67 in accordance with EN 60529
• NFC Link: Magnetic eld strength ≤ 8.5 [A/m (peak)] (at the NFC antenna)
Note 2. Installation
• The equipment must be installed in accordance with EN 60079-14.
• Installation should be in accordance with local installation requirements.
• Control Drawing (ATEX)
F09.ai
Hazardous area
XS770A
Figure8.1 Control Drawing, for ATEX Declaration
(2) Operation
WARNING
When using Sushi Sensor APP for ATEX intrinsically safe explosion devices, the
Android device must comply with the following.
• When using the NFC link in a non-hazardous area, the maximum magnetic eld
strength generated by the Android device is 18 [A/m (r.m.s.)] or less (Compliant
with ISO / IEC 14443).
• When using NFC link in a hazardous area, only Android devices conrmed by
Yokogawa Electric Corporation can be used.
• If additional information and approvals for Android device are required, contact a
Yokogawa representative.
(3) Maintenance and Repair
WARNING
A modication of the equipment would no longer comply with the construction
described in the EU Declaration of Conformity.
Only personnel authorized by Yokogawa Electric Corporation can repair the
equipment.
(4) Nameplate
Please refer to “Figure 2.1 Example of Nameplate”
MODEL: Specied model code.
SUFFIX: Specied sufx code.
S/N : Serial number.
EUI64 : EUI64 address.
TOKYO 180-8750 JAPAN: The manufacturer name and the address*1.
*1:“180-8750” is a zip code which represents the address: 2-9-32
Nakacho, Musashino-shi, Tokyo, Japan.
Revision Information
Title: XS770A Wireless Vibration Sensor Startup Guide
Manual No.: IM 01W06E01-01EN
Edition Date Page Revised Item
1st Feb. 2019 ― New publication
2nd June 2019 1
2
1.2 Add Southeast Asia area
3 Revise Y-axis direction
5 Add conrmation of rmware version
3rd Nov. 2019 1
2
3
1.2 Add North America
2 Add Conversion screw in bundled Items
Delete safe symbol marks