User Manual

<C5. Wiring>

C5-15

IM 01W02E01-01EN

n Wiring of wireless LAN antenna and improvement of environmental

resistance

l Specication of extension cable for wireless LAN antenna

(Use only the cables included as option.)

• Specication: 8D-SFA(PE)

• Outside Diameter: 11.1 mm

• Minimum Bend Radius: 67 mm (when xing)

167 mm (when wiring)

• Cable End Treatment: N type connector, one end is male and the other is female.

* “When xing” shows the bending radius for xing (the state is maintained for a long time).

“When wiring” shows the bending radius while checking the wiring position. This bending

radius is set larger than that for xing in order to prevent damage to the cable because the

cable is likely to be repeatedly bent when checking the nal wiring position.

l Wiring procedure of wireless LAN antenna

1. Use the provided extension antenna cable to connect the antenna connector with the ex-

ternal antenna. Tighten the connector of the antenna extension cable with a torque of 2 to 3

N∙m. Refer to the specication about the limitation of bend radius when xing or wiring.

2. When using two extension cables, the provided arrester should be inserted between these

cables.

3. Before the wiring work, conrm the polarities (male/female) of the connectors of antenna,

extension antenna cable, and arrester.

Tighten the connector of the antenna extension cable with a torque of 2 to 3 N∙m.

FC0513.ai

Wireless LAN antenna

Antenna Extension Cable

Bracket

Mounting YFGW510 to the vertical piping Mounting YFGW510 to the horizontal piping

2-inch pipe

Figure C5-13 Wiring of wireless LAN antenna (single communications)