User Manual

<D2. Setup Tool>
D2-5
IM 01W02E01-01EN
The table below shows the setting items and their default settings.
Item Number of characters Default setting
Serial Port
The number of the port the Infra-
red adapter is connected to
The smallest COM number
among those devices
Login Password
Up to 8 one-byte alphanumeric
characters or other symbols
(e.g., !,$,#)
yokogawa
In the Serial Port eld, enter the COM port number of the Infrared adapter. Open the drop-down
list, then select the COM port number to which the Infrared adapter is connected.
When beginning the program for the rst time, enter the default login password in the Login Pass-
word eld.
Click the [OK] button. The Change Login Password window as shown in Figure D2-5 will appear
if the eld wireless access point setup tool is communicating with YFGW510.
Click the [Cancel] button to exit the setup tool. The window will close.
IMPORTANT
• If the wrong password is entered three times straight, YFGW510 will not accept another
login attempt for 30 minutes. Type in the password carefully.
• Keep the login password safe. It is necessary for setting up the eld wireless access point.
After clicking the [OK] button, if there is a problem in communication between the eld wireless
access point setup tool and YFGW510, the Error window as shown in Figure D2-4 will appear.
FD0204.ai
Figure D2-4 Communication Error window