User Manual
<C5. Wiring>
C5-9
IM 01W02E01-01EN
Bracket 1
ISA100.11a antenna
Antenna Extension Cable
2-inch pipe
Bracket 2
U Bolt
Nut
Washer
Nut and Washer
Bracket
Antenna Extension Cable
ISA100.11a antenna
2-inch pipe
FC0507.ai
Figure C5-7 Fastening external antenna
l Mounting procedure of antenna
1. Fix the antenna extension cable to the bracket 1 with the provided nut as shown in the gure
above.
2. Fix the bracket 1 to the 2-inch (2B) pipe by using the provided a pair of U bolts and bracket
2.
3. Screw the antenna into the antenna connector of the antenna extension cable on the
bracket 1.
Tighten the antenna connector with a torque of 2 to 3 N∙m.
4. Protect the joint of the antenna and the connector with tape. For details on taping, see
C5.4.1 Mounting ISA100.11a antenna to YFGW510.
n Antenna wiring and improvement of environment resistance
l Specication for extension antenna cable
(Only by order of option)
• Specication: 8D-SFA(PE)
• Outside diameter: 11.1 mm
• Minimum bend radius: 67 mm (when xing)
167 mm (when wiring)
• Cable end treatment: N type connector, one end is male and the other is female.
* “When xing” shows the bending radius for xing (the state is maintained for a long time).
“When wiring” shows the bending radius while checking the wiring position. This bending
radius is set larger than that for xing in order to prevent damage to the cable because the
cable is likely to be repeatedly bent when checking the nal wiring position.