User manual

38
1. When entering software update selection and the USB storage device has firmware
image files stored, Fig 6 is shown and followed by Fig 7.
2. Press《 》button to update software.
3. During update process, Fig 8 is shown.
Fig 8
4. Press《MENU 》button to exit “Software Update” selection.
5. When the USB storage device has no firmware images stored, Fig 9 is shown.
NOTE 1: Please do not remove the USB storage device while the firmware has started
updating, otherwise system damage may occur.
NOTE 2: No USB storage device has been connected when entered Firmware Update selection,
Fig 10 is shown.
NOTE 3: Please stop recording before proceeding firmware update, otherwise Fig 11 is shown.
NOTE 4: Please Connect the HDD before proceeding firmware update, otherwise Fig 12 is
shown.