User manual

9
7. OPERATING PROCEDURE
7.1 Power On
After power on, DVR will auto-detect its peripherals (self-testing, auto detects the hard
disk, and etc.).
The system will detect the video input and judge whether the video system is
NTSC or PAL. When video input is unable to be detected (VIDEO LOSS), the system
will send out an alarm (it will not affect the actual recording, but when all (1CH-4CH)
video images disappears, the DVR will stop recording).
7.2 Monitoring Mode
This mode is a default status after power on. Under this mode, system supports
live view for monitoring. Press《 》button, the system enters the manual record
mode, press《 》button to start playback, press《 》button to enter the menu
setup display. During playback, press《 》button to return to monitoring mode.
Under Manual Record mode press《 》button to stop recording and return to
monitoring mode or press《 》button under main menu also returns to monitoring
mode.
During playback, press Stop button to return to monitoring mode or press《 》
button to fast forward: FF1 ( ), FF2 ( ) or FF3 ( ) and press《 》to
rewind playback.
To restore default value: Enter MENU and select item EXIT, proceed “Load Setup
Default” to return to factory default settings (Default Password : 111111). After
returning to LIVE display it will return to factory default setting (111111).