User manual

10
7. OPERATING PROCEDURE
7.1 Power On
After power on, DVR will auto-detect its peripherals (self-testing, auto detects the hard
disk, and etc.)
The system will detect the video input and judge whether the video system is
NTSC or PAL. When video input is unable to be detected (VIDEO LOSS), the system
will send out an alarm, press any button to stop the alarm (it will not affect the actual
recording, but when all (1CH-4CH) video images disappears, the DVR will stop
recording).
7.2 Monitoring Mode
This mode is a default for our system after power on. Under this mode, system
supports live view for monitoring. Press button, the system enters the record
mode, press button to start playback, press button to enter the menu setup
display.
During playback, press button to return to monitoring mode. Press to
change the speed (FF1, FF2 or FF3), or press button to start reverse playback.
 To reset (under quad or single display), press《►》button 5 times, the message
《ALL SETTING DATA IS INITIALIZED.》 will be displayed by flashing 3 times, and
after reset the password will be set as default value (423113).
 When reset procedure has been completed, the message“DVR RESET
COMPLETED. TURN OFF AND ON THE DVR”will be displayed, then
please restart the DVR.