System information

Chapter 13. Virtual Partition Manager 417
7. On the Work with Server Tools User IDs, select option 7 (Change Privileges) for the user
just created as seen in Figure 13-32.
Figure 13-32 Change Service Tools User Privileges
– Partition remote panel key: This is the authority that needs to be granted for virtual
console access.
8. After the required authority has been granted, press Enter.
9. Press the F3 key.
10..The DST is created and configured. Press F3 three times.
11..Press Enter to exit out of System Service Tools.
13.7.3 Starting the Linux installation
At this point all of the components are defined for the Linux environment. You can start the
Linux installation. This section provides the steps for accessing the virtual console and
starting the Network Server.
1. Prior to starting the Network Server, access to the virtual console needs to be achieved so
that messages generated by the installer can be viewed. To accomplished this, use a
telnet client, such as the windows telnet client, and access port 2301 of the i5/OS hosting
partition. As an example, if the IP address of the hosting i5/OS partition is 192.168.10.10
then access to the virtual console is accomplished by entering the command ‘telnet
192.168.10.10 2301’.
Note: In addition to the Partition remote panel key authority, the user id also requires
“System partitions—operations” and “System partitions—administration” authority.