System information

Chapter 10. Using the Advanced Systems Management Interface 327
To allow access to the service processor from any IP address, enter “ALL” in the allowed list.
“ALL” is a valid IP address that can be entered. An empty allowed list is ignored and access is
granted from any IP address.
Denied IP addresses
Enter up to 16 complete or partial IP addresses to be denied. Access to the service processor
is not allowed if a login is received from an IP address listed in this list. To deny access from
any IP address, enter “ALL” in the list. If an incorrect IP address is entered in the allowed list
and the denied list contains “ALL”, access to the service processor may be permanently
denied. In this case, reset the network parameters by using the network reset parameters
switch on the service processor card. Note that an empty denied list is ignored and the
allowed list takes priority over the denied list. For these reasons, “ALL” is not allowed in the
denied list if the allowed list is empty. See Figure 10-76.
Figure 10-76 Confirm network IP addresses allowed and denied
10.3.5 Performance setup
Figure 10-77 shows the expanded Performance Setup menu. Using this menu, you can select
the logical memory block size for the system.
Figure 10-77 Performance Setup menu
Tip: The IP address of the browser you are currently using to connect to ASMI is shown in
the Network Access panel. In our example, Figure 10-75 shows our IP address as:
9.10.136.220