System information

Chapter 10. Using the Advanced Systems Management Interface 307
Refer to Figure 10-41 to see how you can modify the following options for each enclosure that
you select.
Figure 10-41 Configure I/O enclosures
Next we provide a description of these options.
Identify enclosure
Click this button to turn on the indicator on the selected enclosure. You can then visually
inspect the enclosure to see the indicator turned on.
Turn off indicator
Click this button to turn off the indicator on the selected enclosure. You can then visually
inspect the enclosure to see the indicator turned off.
Change settings
Click this button to change the settings for the selected enclosure. The next page displays
options for changing configuration ID, machine type-model, and serial numbers for the
enclosure.
򐂰 Clear inactive enclosures:
Click this button to clear the rack and unit addresses of all inactive enclosures. You might
want to do this if you have removed an enclosure from the system.
򐂰 Power control network indicator:
Enter a hexadecimal number for the power control network identifier.
򐂰 Type-Model:
Enter the machine type and model in the form TTTT-MMM, where TTTT are the four
characters of the enclosure machine type, and MMM are the three characters of the
enclosure model. The enclosure machine type cannot be 0000. All alphanumeric
characters are valid.
򐂰 Serial number:
Enter seven characters for the enclosure serial number. All alphanumeric characters
except o, i, and q are valid