System information

Chapter 4. HMC Guided Setup 121
19.The Guided Setup Wizard - Configure Network Settings panel is now displayed
(Figure 4-19). This completes the network configuration of the private network interface
eth0. We can now proceed with the configuration of the second network card (eth1) for our
open network.
Figure 4-19 Guided Setup wizard - Configure Network Settings
Select the Yes radio button if it is not already flagged. The second ethernet card should be
highlighted in grey (as in Figure 4-19).Click Next to continue with the Guided Setup
wizard.
20.The Guided Setup Wizard - Configure eth1 display is then shown (Figure 4-20). As before,
we can leave the LAN adapter speed at automatic detection for the initial setup. However,
you can set each adapter to your actual network speed if you know this.
Figure 4-20 Guided Setup - Media speed for eth1
Click Next to continue with the Guided Setup wizard.