1 Products and accessories Power Indicator light Type-c Charing Case Tapping Area Status indictor light Auxiliary Micro Main Micro Earphon Working instructions USB
2 Power on&Power off Power On -Open the charging case 3 Power Off -Shut the charging case Operations&Functions Notice: 1 The earphones is using tapping mode, please complete the required operations in tapping area; If the time of tapping for twice is too short or too long, it may no response or causes misoperations; 3 The method of pressing or touching can not make the corresponding functions active.
TAP×2 TAP×2 TAP×3 TAP×2 TAP×2 TAP×3 TAP×4 TAP×4
4 Reset When two earphones can’t be matched, please see below methods to reset . Steps Indicator Light 1- Delete the corresponding Bluetooth connection:"CARD20" in the phone Settings \ 2- Put the earphone into charging case and keep it close After closing, it shows red light 3- Take out two earphone separately and tap 5 times(separately or at the same time) within 40 seconds The red light of two earphones flash 3 times 4- Put two earphones into charging case and keep it close After closing, it s
Waiting to be matched with phones In charging Finish charging No matched Red light Blue light first, then light out Red and Blue light flash Blue light flash Close Open In charging White light flash 4 seconds, then light out white light flash 4 seconds, then light out Corresponding to the battery white light flash Finish Charging Reminder of low battery Three white lights light on and light out after 8 seconds White light flashes, light out after 4 seconds 5 Parameters Bluetooth Version
6 Notice 1- Try to use the minimum volume that we can accept,high volume for a long period of time will lead to permanent damage to hearing; 2- Keep the earphones and accessories out of reach of children, Children should be under of the adult supervision; 3- Don’t immerse the device in water for a long time.
7 Note changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
