User Manual

YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!

 Under 8℃ heating function, set temperature cannot be adjusted. Press "TURBO" button and the remote

controller won’t send signal.

 Sleep function and 8℃ heating function can’t operate at the same time. If 8℃ heating function has been set

under cooling mode, pressing the sleep button will cancel 8℃ heating function. If sleep function has been set

under cooling mode, start up the 8℃ heating function will cancel sleep function.

 Under ℉ temperature display, the remote controller will display 46 ℉ heating.

 Press " " or " " simultaneously to turn on or turn off child lock function. When child lock function is on, " " icon

is displayed on remote controller. If you operate the remote controller, the " " icon will blink three times without

sending signal to the unit.

" " °C and

°F

1. After putting through the power, press "ON/OFF" button on remote controller to turn on the air conditioner.

2. Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.

3. Press " " or " " button to set your required temperature. (Temperature can’t be adjusted under auto mode).

4. Press "FAN" button to set your required fan speed: auto, low, medium and high speed.

5. Press "SWING" button to select fan blowing angle

NOTICE

CHANGING BATTERIES AND NOTICES

1) Press slightly along the arrowhead direction to push the back cover open on the remote control.

2) Take out the old batteries. (As show in figure)

3) Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show in figure)

4) Attach the back cover of wireless remote control. (As show in figure)

NOTICE:

 During operation, point the remote control signal sender at the receiving window on indoor unit.

 The distance between signal sender and receiving window should be no more than 8m, and there should be no

obstacles between them.

 Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone; remote

controller should be close to indoor unit during operation.

 Replace new batteries of the same model when replacement is required.

 When you don’t use remote controller for a long time, please take out the batteries.

 If the display on remote controller is fuzzy or there’s no display, please replace batteries.