User Manual

12
Step 1. Assembling your trainer
1.1 Check all parts and quantity according to the List of components.
1.2 As shown in Figure2, unfold the stand A of the bike trainer on the ground. Make sure the
supporting foot tubes are extended in place.
1.3 As shown in Figure3, Insert the short end of L-type screw rod into the screw rod cover,
And then the other end goes through flat washer, spring, flat washer, the pin, the resistance
unit, and finally screw on the adjusting knob.
1.4 As shown in Figure 4, install the resistance unit on the frame, and tighten the bolts with
the wrenches to make the fixation firm.
1.5 As shown in Figure 5, turn the screws at the two ends of the frame counter-clockwise to
a suitable position, so as to facilitate the installation of the bike.
Step 2. Mounting your bike on the trainer
2.1 First check whether the tire pressure of the bike is at normal state.
2.2 As shown in Figure 6, replace the rear wheel axle of the bike with the quick-release
⑧