User Manual
.
2-in-1 Wireless Charging Pad
User Manual
TROUBLESHOOTING
INFLUENCE
FACTORS
Device Model1
2
Check if your device is compatible,
refer to the COMPATIBILITY list.
Adapter and
Charging Cable
The adapter and the charging cable
must be firmly connected.
Try to reconnect the 18W adapter
and charging cable in the package.
If the problem persists, try another
adapter of 18W or above and
charging cable.
4
3 Protective Case
The thickness of the protective case
(non-metallic) should not exceed
0.2in (5mm).
Try to remove the case and check
again.
Interference
Magnetic/ Metal Attachments (such
as credit cards, keys, etc.) will
interfere the charging.
Please remove them when charging.
SOLUTIONS
2-in-1 Wireless Charging Pad
5
6
Temperature
Do not use this product in a high
temperature environment or expose
it to rain or snow.
Position
7
Defective
Product
Please contact us through Amazon
for technical support following the
steps below if the issue remains.
1. Go to Your Orders.
2. Find your order in the list.
3. Select Problem with order.
4. Choose your topic from list
displayed.
5. Select Contact seller.
When placing the phone, align
the center area on the back of the
phone with the "+".
s
* Please switch off the wireless charger when not
in use. The wireless charger will automatically
switch off when disconnected from its wall charger.
LED INDICATOR
PATTER
INDICATOR
Power on
Stand by
Charging
Fully charged
Suspend charging
Blue light flashes once
Lights off
Blue light stays on for 20s then
goes out
Lights off
Blue light flashes
Left
Right
FCC WARNING UK:
Phone&Earphone
EU:
Declaration of Conformity
Declaration of Conformity
This device complies with part 15 of the FCC Rules. Operation is This device was tested for uncontrolled environment operations.
To comply with RF exposure requirements, a minimum
separation distance of 20cm must be maintained between the
user’s body and the product.
Radiated H-Field -2.4 dBuA/m (@10m)
110-148kHz(Only for EU&UK)TX/RX Frequency Range
This device was tested for uncontrolled environment operations.
To comply with RF exposure requirements, a minimum
separation distance of 20cm must be maintained between the
user’s body and the product.
Hereby, Shenzhen Yifeng Intelligent Technology Co., Ltd.
declares that the product type T2S is in compliance with
Directives 2014/53/EU & 2011/65/EU. The full text of the EU
declaration of conformity is available at the following
internet address: https://www.YFZN.com/
Hereby, Shenzhen Yifeng Intelligent Technology Co., Ltd.
declares that the product type T2S is in compliance with
following Directives: Radio Equipment Regulations 2017,
Electrical Equipment (Safety) Regulations 2016 and The
Restriction of the Use of Certain Hazardous Substances in
Electrical and Electronic Equipment Regulations 2012. The full
text of the UK declaration of conformity is available at the
following internet address:https://www.YFZN.com/
subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions.
However, there is no guarantee that interference will not occur in a
particular installation.If this equipment does cause harmful
interference to radio or television reception,which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
To maintain compliance with FCC’s RF Exposure guidelines, This
equipment should be installed and operated with minimum
distance between 20cm the radiator your body: Use only the
supplied antenna.
Thank you for choosing our product
Watch
Radiated H-Field -25.9 dBuA/m (@10m)
300-350kHzTX/RX Frequency Range
Shenzhen Yifeng Intelligent Technology Co., Ltd.
10th Floor, Building 2, Chaxi, Zone B, Huafeng First Science Park,
Hangcheng Street, Gushu, Baoan District, Shenzhen, China.