Specifications

n
MECHANICAL
BEHAVIOR
按键工作的负荷力
Buttons force
按键工作的负荷力，按键平面中
央垂直施加的最小负荷力
F
L
g
or
gk
y operation, in key
plane Minimum load force applied
vertically by the center
F=130g+40g:
To center as a benchmark
正常
normal
按键高度
Buttons
height
按键未按下的高度H＜3mm
按键按下起作用时的高度H1
不能低于上盖面
shall not be Tower than the
upper cover when the butto
is pressed and the RC is
working
.2
2
0
5
正常
normal
按键强度
Buttons
strength
在按键平面中央垂直施加30N
的负荷力3分钟
Apply 30N vertically in
thecenter of the buttons
planefor 3 minutes
按键无损坏,各功能正常
Buttons are not damaged, all
functions should be normal
正常
normal
按键的负荷寿命
Life of Buttons
以3-5秒的按压频率按键≥
20万次,不到位次数小于或
等于0.5%
Press the button with the
frequency of 3-5 times /second
more than 200, 000 times, and
the number of times not in
position is less than or equal to
0. 5%
按键无损坏， 各功能正常
Buttons are not damaged,
all functions should be
normal
正常
normal
按键的复位
Reset button
分别在按键平面1/4 位置的左
端和右端及按键的左、右、前
、后侧面施加10N的力，按压
三分钟
Apply 10N force on the left end
and right end of 1/4 poslition of
the button plane and the left,
right, front and back side of the
button respectively, press for 3
minutes
按键无损坏，各功能正常
Buttons are not damaged,
all functions should be
normal
正常
normal
遥控器耐压强度
리모컨의 내압 강도
遥控器整体的耐压强度，遥控
器装好电池,对其正面和底面
分别施加100N垂直力15 秒,
Remote control overall pressure
strength, remote control Install the
battery, on the front and bottom of the
device apply 100N vertical force for 15
seconds,
遥控器无损坏且功能正常
Buttons are not damaged,
all functions should be
normal
正常
normal
电源盖板插拔寿命
Remote control
pressure resistance
以2-3次／分钟插拔频率插拔
电源盖板不少于100次
Plug and cover the power
cover at a frequency of 2-3
times/min not less than
100times
无异常
Without exception
正常
normal