Owner manual

ASSEMBLY INSTRUCTIONS

STEP 1. Attach the 2959-203 fert. coulter faceplate w.a. to the planter unit using 3) ½-13 x 1 ½”

bolts, flat washers and locknuts. Use the 1 ¾” OD x ¼” thick washer on the lower large slot. On

some planter units, this washer may need to be trimmed enough not to interfere with a gusset.

Center the bracket on the row unit and tighten the bolts to specification listed on the table on page 4.

STEP 2. Attach the coulter arm 2959-201 to the faceplate using 2) ½-13 x 2 ¾” bolts, flat washers

and lock nuts.

NOTE: The unit-mounted coulter can be assembled as a right hand or left hand coulter

assembly.