User Manual

Programming with Transmitter for HiModel ICE Series ESC
INSTRUCTION MANUAL
♪ ♪ 9kHz
♪ ♪ ♪ 10kHz
♪ ♪ ♪ ♪ 11kHz
♪ ♪ ♪ ♪ ♪ (5) 12kHz
♪ ♪ ♪ ♪ ♪ ♪ (6) 13kHz
♪ ♪ ♪ ♪ ♪ ♪ ♪ (7) 14kHz
♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ (8) 15kHz
♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ (9) 16kHz
Move the stick to full power to select the desired setting(beeps counting) in the submenu.
Acknowledgement: , the setting was saved.
Governor Mode(
♪ ♪ ♪ ♪ ♪ )
Move stick into full back position,
♪ Governor mode OFF
♪♪ Governor mode ON
Move the stick to full power after the hearing the desired beeps. Acknowledgement: , the
setting was saved.
After setting of the speed regulation, the ESC will learn-in the operating speed at the next
start. It is therefore important to wait until you can notice a small speed jump indicating
that the regulation is activated.
If no selection has been made, the above menu options will start over again until a selection is
made.
Note:
The beep starts always with the current setting. This gives a way to sent a feedback to the ESC
settings.
After the setting of any of these parameters, moving the stick back to full back position will arm
the ESC. Alternatively the ESC can be disconnected and reconnected to allow the setting of other
parameters.