User Manual

Programming with Transmitter for HiModel ICE Series ESC
INSTRUCTION MANUAL
For the Advanced Setup, the Basic Setup must have been performed at least once!
1. Make sure that the ESC is off; switch on the transmitter with the throttle stick at full power.
2. Hold the Model, Connect the ESC with motor and battery => a monotonous continuous beep
should be heard.
3.
♪♪♪♪♪♪♪♪....: after approximately 20 tones, the advanced setup is activated as long as the
basic setup has been performed!
Acknowledgement
=> Advanced Setup
If the continuous beeps are not heard, please disconnect immediately the battery from the
ESC and operate everything again. Place the transmitter in a good range of the receiver if
the antenna is not extended.
In the advanced setup only ONE Menu option can be selected, therefore the main menu
choice must take place first:
Place the stick again into full back position to select the main meun to modify:
Main Menu Options overview:
♪ Brake
♪♪ Battery-Typ
♪ ♪ ♪ Timing
♪ ♪ ♪ ♪ PWM-Frequency
♪ ♪ ♪ ♪ ♪ Governor mode
Move the stick to full power after hearing the sounds for the desired parameter.
Acknowledgement:
♪ ♪
Note: If any parameter has not be selected, the menu will begin again with “Brake” and so on; If
selected, depending upon the selection now the ESC switches to the setting of the Parameter.
Possible (sub) menus:
1 Brake (
♪)
Brake selection
(Brake):
Move stick into full back position again
♪ No Brake
♪♪ Brake, Brake is activated if stick range has been configured accordingly.
Move the stick to full power to select the desired setting in the submenu. Acknowledgement:
♪ ♪
After the acknowledgement the menu option is programmed!