User Manual

SHENZHEN XINGQIONG TECHNOLOGY CO.,LTD www.xqcontrol.com
5
Using program card
Adopting 2x16 point LCD panel, program card can make all setting conveniently and directly.
The keys function
KEY
WR
WRWR
WR
FUNCTION
To move the
cursor
horizontally
To move the cursor
vertically and change
item or item value
To confirm selected
item or item value.
To write and save
setting parameter to
ESC
Program procedure
1. Unplug the battery of ESC and connect the PPM wire to program card properly.
2. Connect the battery to ESC, program card will read the parameter from ESC and display on LCD panel.
3. Push to select programmable items and push to enter the item.
4. Use key to move the cursor to proper place ( if it need ), use to select or change item value
(programmable Value ) and push to confirm.
5. When all setting is finished, push WR to save to ESC. After that, you can push to check updated
parameter.
Parameter Display
Item Specification Option or value Default
1.OffVolt
Low Voltage Protection Threshold 00.0V 49.9V
00.0V
2.BrakeType
Brake Mode
Off, Soft brake, Hard brake
Off ( brake disable )
3.AdvanceT
Timing Mode
Low, Mid, High
Mid
4.Start
Start Mode
Fast , Soft , VerySoft
VerySoft
5.OffType
Low Voltage Protection Mode
Reduce ,Close ( shut down )
Reduce
6.Freq=
Frequency of PWM
8KHz,13KHz
8KHz
7.NeutRange=*
set the neutral range of
throttle
0 29%
8 %
8.Curve
Throttle Curve Select C urve 1, C urve 2, C urve 3 Curve1
9.StPercent=
Start Power Percent
00 39%
+00%
10.Model*
Model selection
Car, plane
Plane
11.Reverse
Motor rotation
Normal, Reverse
Normal
12.CarDir*
select direction function One,Two,Two2 Two
*Available in car model only