User Manual

SHENZHEN XINGQIONG TECHNOLOGY CO.,LTD www.xqcontrol.com
4
Program ESC with transmitter
Note: 1. In “Li-xx Cells Number”setting, 1 long “beeb-----” = 5 short “beeb-”. For example,1 long “beeb-----”
plus 3 short “beeb-” ( 5+3 =8 ), means a 8 cells Li-xx battery pack..
2. If a Li-xx battery pack is more than 4 cells, you’d better set the “Li-xx Cells Number” manually.
1. Switch on transmitter ,move throttle stick
to top position,connect the battery pack to
ESC
2. Wait for 2 seconds ,the motor should emit
“beeb-beeb-”tone
3. Wait for another 6 seconds ,special tone
like “♪ i3i3” should be emitted ,which
means program mode is entered
1.Enter program mode
After entering program mode ,you will hear 9 tones in a loop in the following
sequence. If you move the throttle stick to bottom within 2 seconds after one kind of tone,
this item will be selected.
beeb- (1 short tone) Brake
beeb- beeb- (2 short tone) Timing
beeb- beeb- beeb- (3 short tone) Startup mode
beeb- beeb- beeb- beeb- (4 short tone) Cutoff mode
beeb----- (1 long tone) Throttle curve
beeb----- beeb- (1 long 1 short) Li-xx cells
beeb----- beeb- beeb- (1long 2 short) Cutoff threshold
beeb----- beeb- beeb- beeb- (1 long 3 short) Reverse setting
beeb----- beeb----- beeb-----” (3 long stone) Exit
Note: 1 long “beeb-----” = 5 short “beeb-”.
2.Select programmable items
There are two ways to exit
program mode:
1. In step 2, after 3 long tone
(The item #9) please
move throttle stick to the
bottom position within 2
seconds.
2. In step 3,after special tone
♪ 5 6 5 6 , please
move throttle stick to the
bottom position within 2
seconds.
4.Exit program
After entering the item, you will hear several tones in loop, Set the value matching to a tone by moving
throttle stick to top within 2 second when you hear the tone, then you will hear special tone like ♪ 5 6 5 6”. It
means the value is set and saved.
Wait for 3 second, you will go back to step 2, if push the throttle stick to the bottom position within 2
second, you will exit the program mode quickly.
Tone
Items
beeb-
1 tone
beeb-beeb-
2 tone
beeb-beeb-beeb-
3 tone
beeb- beeb-…
N tone
1.Brake Off Soft brake Hard brake
2.Timing Low Mid High
3.Start Mode Fast Soft Very Soft
4.Cutoff Mode Reduce power Shut down
5.Throttle Curve Curve 1 Curve 2 Curve 3
6.Li-xx Cells Number Auto detect 2 cells 3 cells N cells
7.Cutoff threshold Low(2.6V) Mid(2.85V) High(3.1V)
8.Motor Rotation Normal Reverse
3.Set item value