User Manual

SHENZHEN XINGQIONG TECHNOLOGY CO.,LTD www.xqcontrol.com
3
speed, the “High” timing mode is recommended.
4 Start: Fast, Soft and Very Soft. default is Very Soft. Fast start is recommended for low inductance and low
start loading motors, Very Soft start is recommended for high inductance and high start loading motors.
5 OffType(Cutoff Mode,Low Voltage Protection Mode): Reduce power and Cutoff output power for selecting,
default is Reduce the output power gradually to 50% of the current power.
6 Freq=: PWM frequency, 13KHz and 8KHz, default is 8KHz.
7 NeutRange : Throttle neuture range, Available in car mode only.
8 Curve(Throttle Curve Mode): Curve1, Curve2 and Curve3. default is Curve1.
curve1
curve2
curve3
Power
100%
Throttle
Max
0
9 StPercent (Start power) : to set the Percent of output power when motor start in range of 00% - 39%, default
is 00%. Under default setting, output power is decided automatically by system according to throttle stick
position.
10 Model: selection for airplane model or car model ,airplane model only for this serial( XP serial ).
11 Reverse(Motor Rotation): Normal and Reverse. default is Normal.
12 CarDir: Car Model Direction type. Available in car model only.
Program example with transmitter
Setting “Timing Mode”to “High”, i.e. value #3 in program item #2
1 Enter Program mode
Push the throttle stick to the top position, switch on the transmitter, connect battery to the ESC; wait
for 2 seconds, beeb- beeb- will be emitted, then wait for another 6 seconds, special tone ♪ i 3 i 3
will be heard, that means program mode is entered.
2 Select Programmable Items
There are 9 different tones in loop, when you hear beeb- beeb- ( 2 short tone ),push the throttle stick
to the bottom position within 2 seconds, the “Timing Mode”is selected.
3 Set Item Value ( Programmable Value )
There are 3 tones match to 3 item value. When you hear beeb- beeb- beeb- (3 short tone),push the
throttle stick to the top position within 2 seconds, special tones ♪ 5 6 5 6 will be heard, that means
“Timing Mode”is set as “High” and saved.
4 Exit Program Mode
After hearing special tones ♪ 5 6 5 6 , push the throttle stick to the bottom within 2 seconds, you will
exit program mode.