User Manual

PWM-Frequency(♪♪♪♪)
PWM switching rate setting:
move stick again into neutral position:
♪
8kHz
♪♪
9kHz
♪♪♪
10kHz
♪♪♪♪
11kHz
♪♪♪♪♪ (5)
12kHz
♪♪♪♪♪♪(6)
13kHz
♪♪♪♪♪♪♪(7)
14kHz
♪♪♪♪♪♪♪♪(8)
15kHz
♪♪♪♪♪♪♪♪♪(9)
16kHz
At the desired frequency (beep count), move the stick to full power.
Acknowledgement:
♪
♪
Setup done.
Governor Mode(♪♪♪♪♪)
move stick again into neutral position:
♪
Governor mode OFF
♪♪
Governor mode ON
Move the stick to full power to select the desired setting.
Acknowledgement :
♪
♪
Setup done.
After setting of the speed regulation the ESC will learn-in the operating speed at the next start. It is therefore
important to wait until you can notice a small speed jump indicating that the regulation is active.
If no selection has been made, the above menu options will start over again until a selection is made.
Hint:
The beep starts always with the current setting. This gives a way to readback the ESC settings.
After the setting of any of these parameters, moving the stick back to neutral position will arm the ESC. Alternatively the
ESC can be disconnected and reconnected to allow the setting of other parameters.