User Manual

Menu Options overview:
♪
Brake
♪♪
Batt-Typ
♪♪♪
Timing
♪♪♪♪
PWM-Frequency
♪♪♪♪♪
Governor mode
Move the stick to full power to select the desired parameter.
Acknowledgement:
♪
♪
Note:
If no selection is taken, the menu begins again with “Brake” and so on.
Depending upon selection now the ESC switches to the setting of one Parameter.
Possible (sub) menus:
Brake(♪)
move stick again into neutral position:
♪
No Brake
♪♪
Brake activated if stick range has been configured
accordingly.
Move the stick to full power to select the desired setting.
Acknowledgement:
♪
♪
After the acknowledgement the menu option is programmed!
If the stick is taken back to neutral position the ESC is armed and ready for use when the ready signal
sounds. This applies to each programming step.
If no selection is made, the above selection menus start over again at the beginning until a selection is made.
Battery-Typ(♪♪)
Battery selection (Batt-Typ):
move stick again into neutral position:
♪
NiMh
♪♪
2-6Lipo
Auto
♪♪♪
free voltage setup(PC-Setup)
Move the stick to full power to select the desired setting.
Acknowledgement:
♪
♪
Setting done.
Timing(♪♪♪)
Timing setting:
move stick again into neutral position:
The ESC starts with a single beep (30°) and proceed up to 7 beeps (Autotiming).
Example: To set 18° : Move the stick to full power to at the third beep signal.
♪
30°
♪♪
24°
♪♪♪
18°
♪♪♪♪
12°
♪♪♪♪♪
6°
♪♪♪♪♪♪
0°
♪♪♪♪♪♪♪
Autotiming
At the desired beep count, move the stick to full power.
Acknowledgement:
♪
♪