User Manual

be connected to a separate receiver without any special precautions (use of parallel BEC).
The total maximum load is the sum of the individual BEC.
It is also possible configuration without BEC as galvanic isolation. For this, please use our
opto
coupler module.
Please note:
Mainly it is important to make sure that the propeller in circulation, there are no objects
when the battery
connected. Using the cruise control is therefore permitted only in situations where it is not
possible to injure or
destroy something. Damage to the controller (eg. If it is broken, damaged by reversing the
polarity or humidity)
must not be used under any circumstances. Otherwise it would be different in the future
cause failure or malfunction.
ESC to be used only batteries, not allowed to use any other power.
Troubleshooting:
1 beeps / flashes: lever position and / or velocity for Gov.-Store unlearned ?? correctly
2pípnutí / flashes: identification undervoltage
3 beeps / flashes: Warning of rising temperature
5 beeps / flashes: The signaling receiver failed
6 beeps / flashes: start (start) failed
ESC indicates every problem that happens during flight acoustically and visually (sound and
that it goes
see) LED flashing code.
Problems 2 and 3 are indicated only after the motor stops, but the alarm will not end until
problems are eliminated (low voltage / temperature warning). In case the problem led to
the complete
cut off, it will not be enough just Reset via voltage. Clearing can help only because of the
connection
faucet with lever when it is at full power and / or 100% throttle for selection (throttle curve)
and
again, the battery is disconnected after the interval beep. Please allow lever at full power
during
disconnecting, otherwise you activate the RC-setup.
Similarly, problems can be eliminated by activating ProgCard.
If the brake is activated, the problem is announced only after the reset voltage or the
position of the wind
mill.
Warranty:
We provide a 6 month warranty on this speed regulator. Other possible requirements are
included. It
pays particular requirements regarding compensation for injury or damage caused by failure
or
failure. For property damage or injuries and their consequences, which are caused by our
products and
products not accept any liability if we can not control the handling and use
device.