User Manual

most plug on the card, again, brown to the right.
Now plug the flight pack batteries into the ESC.
A series of beeps should be heard if done right, and the programming
card LED's will run and settle to a single solid state.
The top and bottom buttons scroll, and the bottom right button enters
the function. Each time this button is pressed a beep must be heard, if
not, no programming is taking place.
Please note, the factory default is for heli's. Its is there fore necessary
to go to the helli page, page 2 to set up for a fixed wing aircraft.
Press together the top and bottom buttons, now the left side LED
flashes, this is page 2.
Go to start up speed, and select plane,start with'middle'.
Return to page 1, repeat the press and LED will be solid for page 1.
To check if programming has being accepted, unplug the power lead -
right side plug - and plug back again. Once LED's have settled, scroll
through to confirm the settings.
It is a good idea to terminate the data lead before flying. At times the
ESC will stop working and for no reason start up again. To do this, make
or use a Spectrum bind plug. In other words, connect single and neg.
together and plug this into the data lead.
Enjoy.