Operating instructions

26
3. Fitting a new Door Glass
To maintain safe use of the appliance damaged door glass
must be replaced immediately.
To do this:
3.1 Remove the door, by opening and lifting the door free of the
hinge blocks.
3.2 Lay the door face down on a soft flat surface to protect the
paintwork and glass.
3.3 Remove the glass fixing clips and screws. The old glass can
then be lifted clear of the door.
Note how the glass sealing rope is placed between the
glass and the door.
3.4 Dispose of the old glass safely.
Fixing Screws (x4)
Fixing Clips (x4)
Glass
Glass Seal
Door
1
1 Door
Fixing Screws (x8)
Fixing Clips (x8)
Glass (x2)
Glass Seal
Door (x2)
2
2 Door
3.5 Clean, and re-paint, the rear of the door if required ensuring
all old glue is removed from rope seal channel.
3.6 Clean the screws with light oil and coat with high
temperature anti-seize grease, this will aid future removal.
3.7 Fit a new sealing rope and place the glass into position in
the door.
3.8 Place the glass fixing clips into position and re-fix with the
clean fixing screws, tightening the screws evenly until glass
is held securely.
Do not over tighten the screws as this could break the
glass.
3.9 Fit only original Yeoman ceramic glass, which is suitable to
use in high temperature applications.
3.10 Using the appliance with damaged door glass could cause
dangerous fumes to enter the room or the appliance to over-
fire resulting in damage.
4. Fitting a new Door Seal
To maintain the safe use of the appliance damaged or worn
door sealing rope must be replaced.
To do this:
4.1 Remove the door from the appliance, by opening and lifting
the door free of the hinge pins.
4.2 Lay the door face down on a soft, flat surface to protect the
paintwork and glass.
4.3 Remove old rope and scrape old glue from locating groove.
Door Seal
Door Seal
3
1 Door
Door Seal
Door Seal
2 Door
4
Maintenance & Servicing