Operating instructions

18
1. General
1.1 To make the installation of the appliance easier it is best
to remove the internal components before fitting into the
builders opening/studwork.
PACKING LIST
All Models:
 • User&InstallationInstructions
 • Guaranteecard
 • Pairleathergloves
 • Multi-functionaltool
 • 2xBaffleextensiontubes
 • Castfluespigot
 • Castflueblank
 • Packoffixings
STANDARD FEATURES
All Models:
 • Primaryair(undergrateairforfullmulti-fueluse)
 • Airwash(forwoodburning/cleanglass)
 • Adjustablesecondaryaircontrol(toensurecomplete 
burning of flue gases)
 • Removabledoorhandletool
 • Toporrearflueexitoption
 • Removabledoorcrossoption(2dooronly)
 • Roseorplainprimaryairspinners(1dooronly)
Multi Fuel:
 • Multi-fuelgratesystemforcleande-ashingwhenfitted 
with multi-fuel kit
1.2 For the best results remove the following components as set
out below.
2. Removal of the Log Guard
2.1 To remove the Log guard:
— Lift Log Guard clear of the supporting brackets.
— Rotate to clear the sides of the door opening.
1
Wood
Multi-fuel
Do not use appliance without the Log Guard in position.
Pre-Installation Instructions
3. Removal of the Firebricks
Note: On Exmoor Products only, the baffle must be
removed and refitted before the Firebricks.
3.1 Remove the firebricks as part of the routine maintenance.
This can be carried out without the use of tools after
removing the log guard.
3.2 Allow the appliance to cool fully before removing firebricks.
3.3 Take care when handling, as bricks can become fragile after
use. Life span depends on the type of fuels burnt and the
level of use.
Replace damaged bricks as soon as possible.
3.4 To remove bricks:
Remove the upper side bricks by sliding out from above the
grate supports/cast grate.
Single Door appliances: It is important to remove
bricks on the door catch side (RHS) by sliding the
back edge forward and rotating 45º towards the
centre of the firebox.
The brick should now slide out from behind the
catch.
Wood versions have two lower side bricks. Remove in the
same manner as the upper bricks, below the grate supports.
Note: Chamfers are positioned against the appliance body
Replace in reverse order
Lower bricks in
wood stove only
Upper Side
Bricks
Upper Side
Bricks
2
4. Removal of the Baffles
Note: On Exmoor Products only, the baffle must be
removed and refitted before the Firebricks.
4.1 The appliance is fitted with a Baffle in the top of the firebox
to maintain efficient combustion.
4.2 Allow the stove to cool fully before removing the Baffle
system.
4.3 Remove the Log Guard and Firebricks from the appliance to
give access to the firebox.