Operating instructions

10
Remove the baffles and clear the debris
(see Pre-Installation Instructions, Section 4).
10.6 To refresh painted finishes a touch up spray is available.
Contact your Yeoman retailer quoting the serial number
found on the appliance data badge.
10.7 Check that the door(s) shut properly and creates an
effective seal.
Leaking door seals prevent the appliance working properly.
Do not use aerosol sprays near an operating appliance.
11. Cleaning Glass
11.1 Keep the glass clean with correct use of the Airwash system
and good quality fuel. Use the boost setting to clear any
build up.
11.2 Sometimes additional cleaning may be required.
Before undertaking this operation allow appliance to cool
fully. Do not clean hot glass.
11.3 On appliances with printed glass do not use cleaning
agents that have a high alkaline or acidic content, for
example Stovax Gel Cleaner, these are aggressive
cleaning agents designed to be used with heavily
stained clear glass. On printed glass surfaces, use
Stovax Glass Cleaner (Stovax No.4103) which is better
formulated for this application.
11.4 Before applying a cleaning agent remove any dust and
loose soot with a damp cloth.
11.5 Use an appropriate glass cleaner. Apply the cleaning fluid to
a cloth before rubbing onto the glass.
Apply carefully and do not apply excessively. Try to prevent
any run off which could soak into the rope seals around the
edge of the glass.
Soot can also contain acidic particles that can cause
corrosive damage to printed glass.
11.6 Remove dirt with a moist cloth and buff dry.
11.7 Before relighting the appliance ensure the glass is fully dried.
If the rope seal has absorbed excess cleaning agent it
is advisable to replace the rope as soon as possible to
preserve the printed finish of the glass.
12. Chimney Sweeping
12.1 To maintain safe and efficient use of the appliance, the
chimney/flue must be inspected and swept at least once a
year by a qualified chimney sweep*.
If the appliance is used continuously throughout the year,
or it is used to burn wood, more frequent sweeping is
recommended.
The best time to have the chimney swept is at the start of
the heating season.
12.2 The chimney, any connecting flue pipe and the appliance
flue ways, if incorporated, must be regularly cleaned.
12.3 Ensure adequate access for cleaning where it is not
possible to sweep through the chimney.
User Instructions
12.4 If the chimney is believed to have previously served an open
fire it must be swept a second time within a month of regular
use after installation.
13. Care Of Stove
Yeoman has a range of cleaning and maintenance products
and accessories to keep your appliance in good working
order. Your Yeoman retailer can advise you on suitable items
for your stove and provide genuine spare parts such as
replacementglass,doorsealingropeandrebricks.Viewthe
extensive range at www.yeomanstoves.co.uk by clicking on
Accessories. In addition, an annual service by a competent
engineer is recommended to keep your stove in the best
possible condition.
14. Seasonal Use
14.1 Clean and service the appliance if not used during the
warmer months, as detailed in the Maintenance and Servic-
ing section.
14.2 Set the air controls to 50% to keep the appliance ventilated
and stop the build-up of any moisture inside.
14.3 Before re-lighting the appliance:
—Remove the baffles.
—Clear any debris that may have accumulated.
—Check the flue is clear of any blockages.
*Registered on the Competent Persons Scheme (GB
only) see page 32/ INFO (Republic of Ireland).