Specifications

STAGE 4

Position the top centre matrix as shown in Fig.10,

noting that on Natural Gas appliances the Top Matrix is

pulled right forward to touch the front matrix, for LPG

it should be positioned back from the front matrix

supported on the two protruding extensions.

Note that there is a larger air space between the front

and rear matrix for LPG.

STAGE 5

Place the 5 small Ceramic Coals across the front and

the one larger coal in the central position as shown in

Fig. 11, locating the coals into the cutouts in the

matrices.

11. ARRANGING THE LAYOUT

OF THE LOGS

Only the ceramic Logs supplied with this appliance are

to be used. The Logs must be laid only as shown on the

following pages.

Replacement logs and ceramic mat are available from

your dealer, but should only be installed by a CORGI

registered engineer.

The parts required for the log layout are listed below:-

1 Ceramic Mat

1 Bag of Embers

1 Left Rear Log

1 Right Rear Log

1 Large Centre Log

1 Centre Front Log

STAGE 1

Lay the embers on top of the white ceramic mat as

shown in fig 12. Making sure the pilot is not covered.

STAGE 2

Place the large centre log at the back of the burner as

shown in fig. 13.

STAGE 3

Lay the right rear log as shown in fig. 14.

USERS INSTRUCTIONS

Fig. 10

PM166-8

Fig. 11

PM166-9

Fig. 12

PM166-10

Fig. 13

PM166-11

Fig. 14

PM166-12