Specifications

7. ARRANGING THE LAYOUT OF THE
COALS
Only the ceramic coals supplied with this appliance are
to be used. The coals must be laid only as shown on the
following pages.
Replacement coals, ceramic and mat are available from
your dealer.
The parts required for the fuel effect layout are listed
below: See Fig. 6 to identify components.
1 Front Matrix left
1 Front Matrix right
1 Rear Matrix left
1 Rear Matrix right
1 Top centre Matrix
5 Small Ceramic Coals
1 Large Ceramic Coal
1 Ceramic Mat
8. PROCEDURE FOR ARRANGEMENT
Ensure that the Pilot Assembly remains unobstructed
when arranging the matrix and coals.
Note that there is a viewing slot in the front matrix
such that the Pilot Flame will be visible when lit, this
must also be kept clear.
Please note that once the stove is lit, the coals become
very hot, care must be taken when adjusting coals after
the appliance has been lit and Yeoman Stoves accept no
responsibility for any injury sustained whilst handling
hot ceramics.
STAGE 1
Lay the Ceramic Mat on top of the Burner as shown in
Fig. 7 making sure that all holes including the small
cross lighting holes are not blocked, and that the pilot
assembly is not obstructed.
STAGE 2
Place the rear left & right matrices on top of the mat
and burner as shown in Fig. 8, the matrices should be
placed with the rear underside slot locating over the
back of the burner Nat Gas, or the front slot located
over the back of the burner for L.P.G.
STAGE 3
Place the front left & right matrices as shown in Fig. 9,
noting that the matrices are with the locating lugs on
the under side against the front edge of the burner tray,
ensuring that where the two front matrices meet is
directly above the centre of the pilot head. Note that
the burner holes must still be visible after the front
matrices are in position.
USERS INSTRUCTIONS
8
Fig. 6
PM166-4
Fig. 7
Fig. 9
PM166-5
PM166-6
PM166-7
Fig. 8