Specifications

c) Running the stove at low setting
1. Ignite permanent pilot and run stove at “HIGH” setting
for a minimum of 10 minutes as shown in Fig. 2.
2. With the right-hand control knob at the highest setting,
rotate in a clock-wise direction to the lowest setting
(filled circle). See Fig. 3.
d) Extinguishing the stove back to permanent pilot
setting
1. From any heat setting, turn the left-hand knob in a
clockwise direction to the “PILOT” position (a smaller
flame is shown). See Fig. 4
e) Extinguishing the stove fully
1. From any heat setting, turn to “PILOT” as in Fig 4.
2. Depress the same knob slightly and turn clockwise to
“OFF” position (filled circle). See Fig. 5.
5. TWIN ROTARY CONTROL with
OPTIONAL REMOTE
Light the pilot as described in section 4.1a.Turn left
hand control anti-clockwise until it is on the large
flame setting. You are now able to use the remote
control. To increase the flame, the top button should be
pressed. Pressing the lower button on the handset will
reduce the flame. It is also possible to turn the main
burner all the way down so that it is effectively off,
leaving only the pilot ignited.
5.1 TIMER REMOTE CONTROL
TRANSMITTER FUNCTION
SET THE DISPLAY
After connecting the battery or by simultaneously
pressing AUTO and TIMER, the display flashes. You
are in set mode.
From set mode, press AUTO to switch from Degrees F
(and 12 hour clock) to degree C (and 24 hour clock) or
vice versa.
The display will automatically return to manual mode
after some time, but you may immediately return to
manual by depressing the TIMER button.
SET THE CURRENT TIME.
After connecting the battery or by simultaneously
pressing AUTO and TIMER, the display flashes. You
are in set mode.
From set mode, press
▲ to set the hour and ▼ set the
minute.
Wait or press TIMER to return to “manual” mode.
PROGRAMMING THE DESIRED SET
TEMPERATURE
Press AUTO until the display flashes.
Press
▲ or ▼ to set the desired temperature.
Wait or press AUTO to switch to automatic mode.
A sensor in the transmitter measures room temperature.
The controller compares the room temperature with the
set temperature and sends a signal to the receiver to
turn the gas valve motor, which adjusts the flame height
accordingly.
PROGRAMMING THE TIMER
Press TIMER until P1
✷ flashes (period 1, heating cycle
on).
Set the time for the beginning of the first heating period
by pressing
▲ for hour and ▼ for minute.
Press TIMER again; P1
 appears.
Set the time for the end of the first heating period.

USERS INSTRUCTIONS
6
Fig. 3
PM164-3
Fig. 4
PM164-4
Fig. 5
PM164-1
Fig. 6
PM164-6