Specifications

STAGE 3

Lay the right rear log as shown in fig. 11.

STAGE 4

Lay the left rear log as shown in fig. 12.

STAGE 5A (LPG ONLY)

For LPG appliances place the front centre log as shown

in fig. 13.

STAGE 5B (NATURAL GAS ONLY)

For natural gas appliances place the front centre log as

shown in fig. 14.

4. OPERATING THE STOVE

SEE USERS SECTION

5. FITTING THE CANOPY

All Exminster gas stoves are supplied with bolt on top

options. The tops are fixed to the stove body using two

M8 nuts and M8 penny washers.

First place the top (either Flat Top or Canopy) on to

the body, locating the studs on the underside of the

canopy through the holes in the top of the stove.

Apply the washer and nut from the inside top of the

stove, whilst the doors are still open, to fix the top and

seal the appliance.

It is important to check that these nuts are tight and

that no spillage can occur, a smear of fire sealing

compound should be used on the washer and nut, to

guarantee the seal. The stove must be checked for

leakage as part of the commissioning by the installer.

6. THE REMOTE CONTROL

Refer to installation instructions supplied with remote

control unit for fitting motor and reciever.

This requires no external power to operate.

The receiver unit can be hidden under or behind the

appliance, ensure that the receiver is located in an area

that has a temerature below 60°C, and that the

customer knows where the receiver is for future battery

replacement.

INSTALLATION INSTRUCTIONS - INSTALLATION

Fig. 12

PM166-13

Fig. 13

PM166-14

Fig. 14

PM166-15

Fig. 11

PM166-12