Specifications

STAGE 3
Place the Front left & right Matrices as shown in Fig. 6,
noting that the front matrices are positioned with the
locating lugs on the under side against the front edge of
the burner tray. Ensure that where the two front
matrices meet is directly above the centre of the three
flame pilot head. Note that the burner holes must still
be visible after the front matricies are in position.
STAGE 4
Position the Top middle Matrix as shown in Fig.7,
noting that on Natural Gas appliances the Top Matrix is
pulled right forward to touch the front matrix, for LPG
it should be positioned back from the front matrix
supported on the two protruding extensions. Please
note that there is a larger air space between the front
and rear matrix for LPG.
STAGE 5
Place the 5 small Ceramic Coals across the front and
the larger coal in the central position as shown in Fig. 8,
locating the coals into the cutouts in the Matrices.
3. ARRANGING THE LAYOUT
OF THE LOGS
Only the ceramic Logs supplied with this appliance are
to be used. The Logs must be laid only as shown on the
following pages.
Replacement logs and ceramic mat are available from
your dealer, but should only be installed by a CORGI
registered engineer.
The parts required for the log layout are listed below:-
1x Ceramic Mat
1x Bag of Embers
1x Left Rear Log
1x Right Rear Log
1x Centre Front Log
1x Large Centre Log
STAGE 1
Lay the embers on top of the white ceramic mat as
shown in fig 9. Making sure the pilot is not covered.
STAGE 2
Place the large centre log at the back of the burner as
shown in fig. 10.
INSTALLATION INSTRUCTIONS - INSTALLATION
14
Fig. 6
PM166-7
Fig. 7
PM166-8
Fig. 8
PM166-9
Fig. 9
PM166-10
Fig. 10
PM166-11
PM166-6
Fig. 5