User Guide

ManualsBrandsYEMIUGO ManualsIndustrial & ScientificTemperature Controller Module DC 12V Programmable Digital Thermometer Dual LED Display Thermometer with K-Type Thermocouple Thermostat High Precision Sensor Probe -60℃-500℃

Temperature Controller Module

Ⅰ. Introduction

It is a K-type Thermocouple Controller that sensing the ambient

temperature with a K-type thermocouple and displaying it on the display

in Celsius. it with Programmable work mode and use industrial-grade

K-Type sensor to make temperature measuring more precision and wide,

LED display in Celsius

Ⅱ.Parameters:

1. Work voltage:DC 12V

2. Temperature type:Celsius

3. Measure range:-60C~500C

4. LED Display:Red/Blue 3Bit

5. Length of sensor:0.4meter

6. Load voltage:DC 1V-14V or AC 1V-125V

7. Load current:10A(Max)

8. Refresh rate:0.5s

9. Output type:Relay output(It can not output voltage!)

10. Measurement accuracy:1C

11. Size for display:79*43*26mm

Summary of content (6 pages)

PAGE 1
Temperature Controller Module Ⅰ. Introduction It is a K-type Thermocouple Controller that sensing the ambient temperature with a K-type thermocouple and displaying it on the display in Celsius. it with Programmable work mode and use industrial-grade K-Type sensor to make temperature measuring more precision and wide, LED display in Celsius Ⅱ.Parameters: 1. Work voltage:DC 12V 2. Temperature type:Celsius 3. Measure range:-60C~500C 4. LED Display:Red/Blue 3Bit 5. Length of sensor:0.4meter 6.
PAGE 2
Ⅲ.Button/Display Introduction: 1. Long press means need to keep press for more than 3second. 2. SET: Short press to add 50Celsius for the Setting Temperature Value and select set parameters in parameter setting mode. Long press enters into parameter setting mode. 3.UP: Short press button to increase parameter value in the minimum unit. Long press button to increase parameter value continuously. 4. DOWN: Short press button to decrease parameter value in the minimum unit.
PAGE 3
Ⅴ.Set Parameter: 1. Long press SET enters into parameter setting mode. 2. Short press SET to switch select parameter. 3. Press button UP and DOWN to set the parameter value. 4. P00: Set Working Mode. Heating Mode H and Cooling Mode C.The default mode is H. 5. P01: Set Return Temperature Value. The set range is 0C-50C. The default value is 2C. That is to set the range for Set Temperature Value. If set the Set Temperature Value is 25celsius and the Return temperature is 0.5celsius.
PAGE 4
screen will flash '---' when the test temperature is less than Lower Temperature Limit Value. 9. P05: Lock Parameter. Users can not change parameter if turn ON this set parameter. 10. Heating Mode: Module will output if the Actual Temperature Value is less than Set Temperature Value - Return Temperature Value. Heating equipment starts working and raises ambient temperature if module connects heating equipment. 11.
PAGE 5
temperatures. 4. Applied to the measurement of boilers, air, liquids, etc. 5. Production workshop. 6. Vegetable cultivation. Ⅷ. Note: 1. Sensor wire should not be connected incorrectly. 2. Power wire attention direction. 3. It is relay output. It can not output voltage. Users need to provide voltage for load. Ⅸ.
PAGE 6