Technical data

PAGE 46
Talkmaster XT ® Software
5.5.2.1.2 HOLD Signal
The configuration of a HOLD signal can be done under Hold Signal.
FIG. 23 RECORDED HOLD SIGNAL
General settings
•Under the setting HOLD signal source you can select the HOLD signal
that you want to use.
With the option ON AIR the signal which is transmitted via the AUDIO 1
interface is used as HOLD signal.
If you select Recorded Hold Signal, the caller hears the Audio signal
stored in the system. The signal is identical for both lines.
• With the use of the slide control Pause between repetition you can set the
pause between the repetitions of the recorded signal. The pause time
ranges from 0 to 3 sec.
HOLD signal recording
•Under Record source you can select the Audio interface via which the
HOLD signal is recorded.
• Via the button Start you start the recording. With Stop the recording is
stopped. With Save the recorded signal is saved in the permanent mem-
ory (FLASH-EPROM) of the system.
• The duration of the recorded HOLD signal is displayed under HOLD sig-
nal duration. The maximum duration of a recorded signal is 16 seconds.
Test recorded HOLD signal
• To test the recorded signal it can be played back.The button Start starts the
play-back of the recording and by Stop it is stopped.