User Guide

yellow tools INDEPENDENCE 1.0
Manual
99
Operation (example)
Before we however begin to explain all available parameters on this page with all details, let‘s start
with an example:
Let‘s assume you loaded a new Layer which contains two different Zones (Samples) - a Conga,
for example. Both Zones do not contain different velocity samples but alternative hits of the same
velocity. So BOTH Zones get layered on the same key (e.g. C#3) AND the same velocity (e.g. 0 to
127), in short: one upon the other! These Zones are named „Conga1“ and „Conga2“, for example.
As already explained in the chapter „Mapping and Audio Editor“ (-> page 81) all Independence
internal editors only communicate with „Sections“, so you now have to switch to the „Mapping“
page and create a new Section for each Zone respectively.
After this is done return to the „Performance“ page, click on the „select“ pull-down menu and select
the „ New Alternate“ option:
Now enter a name for the Alternate right beside the „select“ pull-down (e.g. Conga Alternate) and
confirm with the „Return“ key to instance the new Alternate. As this Alternate is still „empty“ you
now have to select the Sections you want to use for this Alternate. Therefore click on the „Basic
Step“ pull-down „1“. All available Sections get displayed - in this case the Sections „Conga1“ and
„Conga2“. Select the Section „Conga1“...