User Guide

CHAPTER 5
Modules
52
Module Editor
Beside the standard and self-explanatory editing parameters like volume, panorama, pitch and delay
you additionally have the possibility to assign a very custom polyphony limitation that will only
affect your selected Sections or Alternates.
EXAMPLE: To achieve the so-called „hihat effect“ with a self created drum kit, select your
hihat Section in the „select“ pull-down menu or the Content Browser.
Enter the value „1“ into the input filed „key/sel.“ (keys per selection). Now play
the hihat Zones on your keyboard (or another MIDI controller) and you will
notice that always when you play a new note the prior one gets interrupted.
In addition you can assign the fade-out time for the prior note with the „sel. rel.“
(selection release) parameter.
Output Settings
The Output Settings are located on the right side of the first parameter bar. Here you can
immediately route your existing selections to so-called „Custom Channels“ (internal virtual
channels) or assign them to existing or new BUS Channels.
Independence can manage an unlimited number of Custom Channels. These channels enables you to
subdivide a Layer into multiple internal add-on channels which you then can edit individually with
additional modifiers or insert filter and effects.
IMPORTANT: Currently it is not possible to route a Layer directly to a Custom Channel. You
can only route one or multiple Sections and Alternates of a Layer!
Now select one or multiple Sections or Alternates in the „select“ pull-down menu or the Content
Browser. Afterwards an additional pull-down menu beyond the output headline gets displayed.