User Guide

CHAPTER 4
User Interface & Basics
36
Next to the Layer name there are two small arrows that allow fast switching between the available
Layers:
The direction corresponds to the structure of your Layer patches in the Layer pull-down menu, so if
you click the arrow that points upstairs, the current Layer gets replaced with the next Layer ABOVE
the currently loaded Layer in the Layer pull-down menu. The arrow that points downstairs works the
other way around: the current Layer gets replaced with the next Layer BELOW the currently loaded
Layer in the Layer pull-down menu.
As soon as you change any of the editing parameters of the Layer and then click an arrow to switch
to the next Layer, a warning message will show up to avoid the accidental loss of your unsaved
changes.
IMPORTANT: When you switch between Layers with the arrows, your MIDI input channels
get retained to enable continuous playing.
Next to the switch arrows there is a little but very useful level meter that shows the current volume
of the Layer, so you do not always have to switch to the Mixer page.
To delete one or multiple Layers simultaneously press and hold the „shift“ key, click on the Layers
you want to delete and click the „-“ icon afterwards. A warning message will show up to avoid the
accidental deletion of your Layers.
Like the Project Area and the Layer Set area also each Layer contains the useful notepad (infofile)
editor. Use this feature to take some notes for your Layers or visit the author website.