User Guide

yellow tools INDEPENDENCE 1.0
Manual
133
Limiter
A Limiter regulates the output level of the audio signal gently down, before an over-regulation
can take place. Finally the Limiter is also like an „extreme type“ of the compressor, since it
works according to the same principle as the compressor, however the level of the compression is
substantially higher.
Treshold: Determines the value in dB about how much you want to raise the volume of your
audio signal.
Release: Determines how long it takes for the limiter action to stop after the input signal
falls below the treshold level.
Output Gain: The output volume of the audio signal.
Gater
A Gater only lets an audio signal pass through if a determined volume level of the audio signal is
exceeded. With the Gater you can avoid noises of the audio signal and also control its dynamic.
Treshold: Sets the volume level above which the gater lets the audio signal pass through.
Attack: The rise time of the audio signal after it exceeds the treshold level.
Hold: This value balances small fluctuations of the audio signal within the entered time in
milliseconds.
Release: Determines how long it takes for the gater action to stop after the input signal
falls below the treshold level.