User Guide

CHAPTER 10
Insert Filter and Effects
130
Filter Follower
Same as X-Filter. Additionally the Filter Follower changes the settings for „Frequency“ and
„Resonance“ of the selected „Slope“ and „Filter Mode“ in a dynamic ratio to the volume of the
audio signal.
Frequency: Specifies the frequency, above/below which the audio signal gets boosted/cut.
Resonance: Emphasis of the selected frequency from 0% (no emphasis) to 100% (maximum
emphasis).
Slope: Pull-down menu to select the slope.
Filter Mode: Fade between „Low Pass“, „Band Pass“ and „High Pass“ from 0% to 100%.
Intensity: Intensity of the filter.
Attack: The moment the filter will apply after the audio signal started.
Release: The moment as of the filter will not apply any longer after the audio signal softens.
Output Gain: The output volume of the audio signal.
Low Cut Filter
With the Low Cut Filter you can cut low frequencies depending on the selected slope.
Slope: Pull-down menu to select the filter type and slope.
Frequency: Specifies the frequency, below which the audio signal gets cut.