User Guide

yellow tools INDEPENDENCE 1.0
Manual
107
Legato Start
Now you can select your Legato Start Layer, Alternate or Section in the intended pull-down menu.
The available parameters of the Legato Start option are:
Key Range:
Here you can assign the range for the legato simulation.
Skip:
You can only use this parameter if no Legato Option or Legato Target exist. The value sets the skip
time of the next played note of the same Layer.
Random:
This parameter allows a more realistic, humanly sounding „fine tuning“ of the „Skip“ parameter.
Because not always the same Skip value gets used, Random works as dynamic variance from the set
Skip value and thus for a bit more liveliness of the Skip parameter.
Treshold:
This is the slide in time of the upcoming legato note.
T-Curve (Treshold Curve):
As the name implies... :-)
In the pull-down menu of Legato Start you can select the Layer, Alternate or Section you want to
use for the new Legato. You selection in this pull-down is by far the most important parameter! You
can create many different legato modes, and this is even necessarily, because in practice a mezzo-
forte played legato note requires totally different settings than a forte played legato note!